#include <SoftwareSerial.h>

SoftwareSerial mySerial(2, 3); // RX, TX
// Connect HM10      Arduino Uno
//   Pin 1/TXD      Pin 7
//   Pin 2/RXD      Pin 8
// HM BLE terminal
// JBWave

void setup() {
  Serial.begin(115200);
  // If the baudrate od the HM-10 module has been updated you may need to change 9600 by another value
  // Once you have found the correct baudrate you can update it using AT+BAUDx command (AT+BAUD0 for 9600 bauds)
  mySerial.begin(115200);
}

void loop() {
  char c;
  if (Serial.available()) {
    c = Serial.read();
    mySerial.print(c);
  }
  if (mySerial.available()) {
    c = mySerial.read();
    Serial.print(c);
  }
}